Raspberry Pi Relay - GPIO Control

Raspberry PiRelay - The simple approach to Switch Relays using the GPIO Pins on a Raspbery Pi. Control something from 1 to one hundred Relays related to between 1 and 10 totally different RaspberryPi's

INSTRUCTIONS:

1. First run the following 4 commands on your RaspberryPi:

sudo apt-get update

sudo apt-get set up wiringpi apache2 libapache2-mod-php -y

sudo wget https://pirelay.jasonfindlay.com/downloads/gpio.dl

sudo mv gpio.dl /var/www/html/gpio.php

2. Download PiRelay App

3. Set your Pi IP tackle in PiRelay app settings.

Tip: Run command ifconfig in your RaspberryPi to seek out it is IP address.

For extra infomration visit: http://bit.ly/pirelay

PREREQUISITE: You must have a Raspberry Pi to make use of this ap (i.e. https://www.raspberrypi.org/) and then comply with the arrange process to put in the software onto your Pi.

PiRelay is the unique and finest app for use with Raspberry Pi's running the PiRelay software to Switch or Pulse the GPIO pins on up to 10 Raspberry Pi's with Switch/Pulse management of as much as 100 Relays/GPIO pins.

This app can be utilized to regulate just about something that uses an electronic swap to operate.

For instance: Switch on/off Lights, open/shut Electronic Garage Doors, open/shut Gates, Unlock Doors, Control Heating, Cooling and so forth.. Anything you'll be able to think of that you may want to management, should you can wire it up, PiRelay can management it.

** Share a YouTube Video of your Project //** - Use keyword: PiRelayApp to share your creation with the PiRelay neighborhood.

IMPORTANT NOTE: You should observe the instructions to put in PiRelay onto your Raspberry Pi before this app will work.

INSTRUCTIONS: http://bit.ly/pirelay

Ask questions within the PiRelay thread on the Raspberry Pi forum: http://bit.ly/RPiForumPiRelay

Features of PiRelay

- Control up to one hundred Relays

- Use as much as 10 Raspberry Pi's

- Swipe all the way down